Code Alarm or Chapman Remote Programming:
For Remote/System Models: Part# CRCX3 & PT4 FCC ID: GOH-MM6-101890 (Includes 2 and 4 Button Models). Programming Procedure: #1
Programming Procedure #1:
1a: Locate the systems remote programming button. This button is also known as the systems valet/emergency override button. Its the installer's preference exactly where here puts it and he should have indicated this to you after he installed the system. But, in any case, the button is most definately mounted somewhere under the drivers side dash area or along the steering column, the most common place would be on the the drivers side lower left kick panel. Some have even been found just tucked behind some carpeting or behind a panel. After the programming button has been found:
1b: Open the drivers door and make sure the vehicles interior lights turn on. Within 10 seconds:
1c: Turn the vehicles ignition ON (Do not start the vehicle, just turn the ignition into the last position it can be in before actually starting the vehicle). Within 15 seconds the system will either sound 3 times, flash the dash or parking lights 3 times or cycle the door locks up and dowm 3 times (or a combination of the 3). After this is seen or heard, keep holding the programming button in. Within 10 seconds:
1d: Press & hold the top left button on the remote (Lock/Arm Button), within 1-3 seconds the system will sound, flash or cycle the door locks 1 time, after this is seen or heard, release the button on the remote (repeat 1D at this time for any additional remotes within 10 seconds). After all remotes have been programmed, release the programming button:
1e: Turn the ignition OFF and test remote(s) by slowly toggling back & forth from button to button. Done.
Code Alarm Remote Programming:
For Remote/System Models: Part# CATX4/CA-5153
Programming Procedure: #2
Programming Procedure #2:
2a: Locate the systems remote programming button built into the systems antenna. The systems antenna is commonly mounted on the windshield directly behind the rear view mirror.
2b: Turn the vehicles ignition to the ON position:
2c: Press & hold the systems programming button in, within about 10-15 seconds, the system will pulse the vehicles horn 3 times, after this is heard, release the programming button. Within 10 seconds:
2d: Press and release the LOCK button on the remote, the system will sound 1 time in response:
2e: Turn OFF the ignition and test remote by slowly toggling back and forth from lock to unlock. Done.