Vehicle Specific Auto Alarms & Remote Car Starters - Remote Starters for Manual Transmissions

About Installing Remote Starters for Manual Transmissions:

How different is it to install a Remote Starter for a Manual Transmission as compared to a standard system for an automatic transmission vehicle? And how does a manual transmission system ensure a safe start? How does it work? Heres the answers...

Installing a remote starter on a manual transmission vehicle is almost the same as installing a system on a automatic trans, with just two difference's. First, theres one extra wire from the system that needs to be connected to a wire in the vehicle that runs to the vehicles emergency brake. This wire will show a GROUND SIGNAL only when the parking brake is set.

Two, theres a second starter wire output (or ignition output, depending on the vehicle) from the system thats connected to the vehicles clutch activation wire that runs to the vehicles clutch switch, commonly found above the clutch pedal itself. This wire will show a positive or negative polarity (depending on make of vehicle) when the vehicles ignition is on and/or in the start position when the clutch is engaged.

To ensure a safe start with a remote starter on a vehicle with a manual transmission, a set-up procedure, must be followed before you exit the vehicle.

This procedure is commonly called the "REMOTE START READY MODE". The routine to enable, or set, the remote starter is done when parking the vehicle. While the vehicle is still running, you set the emergency brake and place the vehicle in neutral. Then, while the vehicle is still running, you press a button on the remote which will cause the systems status LED to flash along with the parking lights. You then remove the keys from the ignition and will notice that the engine will stay running. Within 15 seconds, you exit the vehicle and after closing the door press a button on the remote that will shut the engine down. Your vehicle can now be remote started safely. If this procedure is not followed exactly everytime before you try to attempt to remote start your vehicle, the remote start feature of the system will not operate.

2W-2000RSM 2-Way Remote Starter for Manual Transmission

Price:

$249.00

Items Remaining:

2W-2000RSM

2-Way Remote Starter w/Keyless Entry for Vehicles w/Manual Transmissions

Includes 1 x 5 Button 2-Way Remote & 1 x 4 Button Standard 1-Way Remote.
Up to 2000 feet of 2-Way Range

Feature's & Operation:

Doors Locked: Pressing the LOCK button on remote 1X (Top Left Button) will lock the vehicles doors, flash the vehicles parking lights 1X and beep the vehicles horn 1X. The LOCK ICON on the 2-Way remote LCD screen will be displayed and the remote will beep 1X.
Doors Unlocked: Pressing the UNLOCK button on remote 1X (Top Right Button) will unlock the vehicles doors, flash the vehicles parking lights 2X and beep the vehicles horn 2X. The UNLOCK ICON on the 2-Way remote screen will be displayed and the remote will beep 2X.
RSRM (REMOTE START READY/SAFETY MODE): Mandatory routine to enable, or set, the remote starter before parking the vehicle. While the vehicle is still running with the key, you set the emergency brake and place the vehicle in neutral. Then, you press the STAR button on the remote 2X which will cause the systems status LED to flash along with the parking lights. You then remove the keys from the ignition and will notice that the engine will stay running. Within 15 seconds, you exit the vehicle and after closing the door press a button on the remote that will shut the engine down. Your vehicle can now be remote started safely. If this procedure is not followed exactly everytime before you try to attempt to remote start your vehicle, the remote start feature of the system will not operate.
Remote Starter Activation: Pressing the STAR button on remote 2X (Bottom Right Button) will activate the remote starter feature (Only after the system has been placed into the RSRM). The 2-way remote will chime and the vehicles parking lights will flash 1X indicating remote start activation. Then the IGNITION ICON on the 2-Way remote screen will begin to flash on the display. This indicates that the vehicles ignition system is being energized. Within 5 seconds the remote starter system will crank the engine over. Once the engine is running, the vehicles parking lights will turn ON SOLID and the EXHAUST ICON will begin to flash on the 2-way remote screen. The 20 minute remote start RUN TIME will also be displayed and begin to count down. The system will now apply power to activate the vehicles HEATER and/or AC circuit.
Status LED
Auto Shut-Down: The remote starter system will automatically shut down the vehicle after the 20 minute run time has elapsed OR the system can be shut down sooner, if desired by pressing the remotes STAR button again 2X the same way you did to activate the remote starter system.
While the vehicle is running via the remote starter: Enter the vehicle and insert the key into the ignition and turn the ignition ON. As you press on the vehicles brake pedal to shift the vehicle into gear, the remote starter will automatically shut down and allow the vehicle to run on its own without having to restart the engine. Note that if the vehicles brake pedal is pressed before the ignition is turned ON, the engine will shut down.
20 Minute Remote Start Run Time.
3 Minute Turbo Cool-Down Mode for turbo equipped vehicle's (Cool down time can be installer adjusted up to 5 minutes if desirable).
Pit-Stop Mode: While the engine is running with the key and before turning the engine OFF, press the STAR button on the remote 2X slowly. Turn the ignition OFF and remove key. The engine will remain running for the full 20 minute run time. This feature is used for occasions when you wish to exit the vehicle for short periods of time but would like to leave the engine running with the HEATER or AC ON and the doors locked. The remote door lock & unlock stay fully functional.
Silent Lock or Unlock: Press & releasing both the LOCK & UNLOCK buttons at the same time will either lock or unlock the vehicles doors without beeping the vehicles horn. Only the parking lights will flash. If the doors are already locked when both buttons are pressed, the doors will automatically unlock, if the doors were unlocked, they will lock.
Car Finder: While the 2-way remote screen indicates that the doors are locked, Press the LOCK Button on the remote 1X. The remote will sound and the vehicles horn will beep 6X and the vehicles parking lights will flash 12X. This feature is used for locating the vehicle in crowded parking lots. Please note that this feature only works if the doors were locked using the systems remote first.
Remote Button Lock: Press & release the remotes F button 1X, then immediately press & hold the LOCK button on the remote until the KEY ICON appears in the upper right corner of the 2-way remote screen. This feature is used to disable ALL the buttons on the remote if you want to temporarily inhibit the remote from functioning completely. To re-enable the remote, just repeat the same procedure until the KEY ICON disappears.
Remote Back-Light: Press & Hold the F Button in the center of the remote (FUNCTION BUTTON) until the remote beeps. This will turn ON the 2-way remotes back-light for 5 seconds for viewing the screen at night.
Battery Power Icon: The BATTERY POWER ICON is continuously displayed at the bottom left corner of the 2-way remote screen. 3 black bars indicate a full battery. The battery should be replaced when only 1 black bar is displayed. Uses a common AAA battery (included).
Remote Power Trunk (or Hatch) release output (Vehicle must have existing factory power trunk or hatch release switch).
2 Year Parts Replacement Warranty
2 Auxiliary Output Channels (- Negative): Installer adjustable auxiliary outputs can be programmed for 1 second momentary or Latched.
VSS Vehicle Specific System: You will be asked to indicate the Year, Make & Model of the vehicle this system is going to be installed into at checkout, along with a check-list of options that may pertain to the specific vehicle.
Step-By-Step System-to-Vehicle Specific Installation Manual. Wire to wire installation guide that indicates exactly what wire from the system goes to what wire in the vehicle and where that wire is and how to verify it using the supplied test probe.
Complete Installation Connector Kit w/Air-Bag & Computer Safe Test Probe.
For Vehicles with Fuel Injection & Manual Transmissions Only!
Tech Support available via Email or Phone 7 Days a Week.
SPECIAL Add Any Needed Bypass Kit w/Remote Starter Purchase for Only $39.95! Save Up to $40.00! Discounted price offered when you click-on "Buy Now" or "Add to Cart".

Optional Upgrades:
Available 2nd 2-Way Remote Option: Add a Second 2-Way Remote for the system at the discounted price of $52.95. Save Over $20.00 when bought separately (Offered during Check-Out)